Zum Aufbau des Filters im HSR-Kanal wird eine Jodzelle genutzt.
Ein ca. 40 cm langes Glasrohr mit 2 optischen Fenstern an den Stirnseiten wurde erst evakuiert und dann mit Jod (unter Ausnutzung seines Gleichgewichtsdampfdrucks von 137 Pa) bei 40 °C befüllt.
Diese Zelle wurde in eine temperierte Halterung eingebaut, deren Temperatur bei Betrieb konstant auf 35 °C gehalten wird.
www.tropos.deAn iodine cell is used to build the filter in the HSR channel.
An approximately 40 cm long glass tube with two optical windows on its fronts had been evacuated and then filled with iodine (taking advantage of its equilibrium vapor pressure of 137 Pa) at 40 ° C.
This cell was installed in a temperature-controlled mounting, whose temperature is kept constant at 35 °C during operation.
www.tropos.de250 µm oder Flutrakel
VISKOSITÄT(PA.s) und NASSKLEBEKRAFT (Pa) gemessen mit einem Physica Rheometer mit einem Platte-Platte Meßsystem(PM30) bei einem Abstand von 200 µm und einer Meßtemperatur von 23°C .
www.solderchemistry.com250 µm or flood squeegee
VISCOSITY(PA.s) and WET STRENGTH(Pa) measured with a Physica Rheometre with an plate to plate measuring system(PM30) at a distance of 200 µm and a measuring temperature of 23°C.
www.solderchemistry.comParameter der Filtermateriale :
Durchlässigkeit ab 20 bis 500 l/m2/s bei einem Druckverlust von 200 Pa
www.filkom.czFilter materials parameters :
Permeability from 20 to 500 l/m2/s with 200 Pa pressure loss
www.filkom.czDazu ein Beispiel :
bei 6 bar Leitungsdruck messen Sie einen Durchfluss von z.B. 350 Nm³/h mit einer 2-Zoll-Düse bei einem Wirkdruck von etwa 10 mbar (1000 Pa).
www.optiserve-messtechnik.deAn example :
at a line pressure of 6 bar a volume flow of, e.g., 350 Nm³/h is measured with a 2"-nozzle at an effective pressure of approx. 10 mbar (1000 Pa).
www.optiserve-messtechnik.detech_01
Bei den empfohlenen Spannungswerten 200 V DC und 10 V AC Generatorsignal und einem Übertragungs- faktor des Mikrofons von 50 mV/Pa beträgt die Ausgangsspannung des Messmikrofons etwa 5 mV bei einem Klirrfaktor von 2 %;
das entspricht einem Schalldruck von 74 dB.
www.microtechgefell.detech_01
At the recommended voltages 200 V DC and 10 V AC generator signal and the microphone’s sensitivity of 50 mV/Pa the output voltage of the measuring microphone is about 5 mV with a distortion factor of 2 %.
This corresponds to a sound pressure level of 74 dB.
www.microtechgefell.deUrsprünglich Telok Ayer Market.
Die chinesische Bezeichnung Lau Pa Sat bedeutet "alter Markt".
universes-in-universe.deErweiterte Mechanische Belastungstests
In der mechanischen Belastungsprüfung entsprechend dem Standard IEC 61215 werden PV-Module mit drei Druck- und Zugbelastungszyklen von jeweils ± 2400 Pa getestet;
für besondere Schneebelastungsfälle wird die letzte Druckbelastung mit 5400 Pa durchgeführt.
www.ise.fraunhofer.deExtended Mechanical Load Test
In mechanical load tests according to standard IEC 61215 PV modules are tested with three cycles of pressure and suction, respectively ± 2400 Pa.
If heavy accumulations of snow and ice are to be simulated, the last pressure load is performed with 5400 Pa.
www.ise.fraunhofer.dePA - Togetherness in life
Den Veranstaltern zufolge repräsentiert das koreanische Wort "Pa" (siehe Schriftzeichen) ein offenes Bild des Meeres, das für die regionale Charakteristik von Busan steht.
universes-in-universe.dePA - Togetherness in life
According to the organizers, the Korean word "Pa" (see character) represents an open image of the sea, which reflects the regional characteristics of Busan.
universes-in-universe.deließen sich neben Landrat Harald Kühn, Bürgermeister Thomas Schmid und Ehemann Christian Neureuther auch viele Passanten so richtig schmecken.
Die WM-Maskottchen Ga & Pa verwöhnten mit ihrem Rezept, leckeren „Schneebällchen", die Gäste.
www.gap2011.comwas enjoyed thoroughly by District Administrator Harald Kühn, Mayor Thomas Schmid and husband Christian Neureuther as well as many passers-by.
The World Championships mascots Ga & Pa treated the guest to their own recipe, delicious "snowballs".
www.gap2011.comAbb. 2 :
Messung des HF-Stromes und der HF-Spannung sowie deren Auswertung am Beispiel einer Cu-Probe, 770 Pa, f = 3.3 MHz, U0P = 675 V, Ppl = 9,8 W
Abb. 3:
www.ifw-dresden.deFigure 2 :
Voltage and current signal sputtering a copper sample ( 770 Pa, f = 3.3 MHz, Ppl = 9,8 W).
Figure 3:
www.ifw-dresden.deMöchtest du ein Wort, eine Phrase oder eine Übersetzung hinzufügen?
Sende uns gern einen neuen Eintrag.