eingesetzt.
Ein ansteigender Strom in den Poloidalfeldspulen treibt wie bei einem Transformator einen Sekundärstrom im Plasma;
das hierdurch erzeugte ergänzende Magnetfeld komplettiert den Plasmaeinschluss.
www.bmbf.dePoloidal field coils are used for correction.
An increasing electric current in the poloidal field coils generates a secondary current in the plasma, similar to a transformer;
this secondary magnetic field completes the inclusion of the plasma.
www.bmbf.deWill man z. B. einen Widerstand Rx von etwa 10 kOhm mit einem Normalwiderstand RN = 100 Ohm vergleichen, dann wählt man für das Verhältnis der Stromstärken IN / Ix = I1 / I2 = 100 und entsprechend für die verwendeten Windungen des Komparators N1 / N2 = 1 / 100.
Der Sekundärstrom I2 durch die Sekundärwicklung N2 wird durch das SQUID-System in einer Rückkoppelschleife (Feedback) so geregelt, dass Durchflutungsgleichgewicht I1N1 = I2N2 herrscht, d. h. der magnetische Gesamtfluss im Komparator (~ Bext) Null ist.
Vergleicht man Widerstände, deren Verhältnis nicht sehr nahe einem Windungszahlverhältnis N1/N2 entspricht, so bedient man sich einer zusätzlichen Hilfsschaltung (in der Abbildung grau dargestellt):
www.ptb.deThus, to compare Rx of about 10 kOhm with a standard resistor of RN = 100 Ohm, you choose IN / Ix = I1 / I2 = 100 for the current ratio and N1 / N2 = 1 / 100 for the ratio of the windings in the CCC, respectively.
The secondary current I2 through the windings N2 is adjusted by the SQUID system using a feedback circuit so that flux balance (I1N1 = I2N2) in the CCC is achieved.
For the comparison of resistors with resistance values that do not correspond to a winding ratio N1/N2 very closely, an auxiliary circuit is used (shown in grey color in the figure):
www.ptb.deMöchtest du ein Wort, eine Phrase oder eine Übersetzung hinzufügen?
Sende uns gern einen neuen Eintrag.